Direct answer
Unplug or power down the system, empty the bin, remove hair from documented removable parts, and clean or replace filters only as directed. Wipe pet-contact tools with an approved method and allow washed components to dry fully before reassembly.
Sort the kit by cleaning method
Before reaching for water, separate the base, bin, filters, hose, grooming heads and clipper. A kit is not one washable object. Use the manual to assign each part an approved action: empty, dry-brush, wipe, rinse or replace. If a method is not stated, ask support rather than infer it from the material's appearance.
Keep the clipper's care instructions separate from the vacuum's. A removable comb, a cutting blade and a motorized handle can require different treatment despite arriving in the same box. This sorting step prevents a quick cleanup from becoming a damaged-electronics problem.
Disconnect, then contain the collected hair
Finish grooming and move the pet away from the cleanup area. Switch off and disconnect the relevant power supplies before removing parts. Open the bin by its documented release and empty it over a suitable waste container. Do not shake a full bin across the room or press collected hair deeper into it to delay emptying.
With the bin removed as instructed, inspect the accessible closing edges for trapped hair. A hair-free mating surface is easier to check than one hidden beneath debris. Leave fixed internal screens, wiring and the motor housing alone; cleaning the kit does not call for dismantling the appliance.
Clean contact tools without spreading liquid
Remove visible hair from permitted removable tools using the stated method. Dyson, for example, specifies a damp-cloth wipe for its pet groom tool, extension hose and quick-release adapter. That is not a soaking instruction, and it should not be transferred to other brands or motorized attachments.
Do not spray cleaner through a connected hose or into an electrical housing. Check both the tool instructions and any cleaning product's label before using chemicals on a pet-contact surface. Routine debris removal is not automatically disinfection. For suspected infectious skin problems or contamination, ask the veterinarian and equipment maker about an appropriate method.
Give filters their own decision
Inspect the exact filter and follow its designated care process. Do not wash it because another kit's HEPA filter is washable, or brush delicate filter material aggressively to make it look new. Keep all required layers in place when the machine returns to service.
If a part is approved for washing, follow the stated drying method and wait until it is fully dry before reassembly. The Neakasa P1 Pro instructions explicitly require drying its cleaned dust cup before reinstalling it. Treat the available drying space and time as part of cleanup, not an inconvenience to work around.
Reassemble once everything is ready
Check that the correct dry components return to their documented positions and that latches close normally. Store the hose without forcing a tight bend and keep sharp grooming tools protected. Set aside anything damaged or uncertain so it cannot accidentally enter the next session.
If the machine still collects poorly after routine cleaning, switch to diagnosis. Note what was cleaned and whether the problem existed beforehand. Repeating the whole wash cycle is not a substitute for locating a blockage, an assembly issue or a fault requiring support.
Before you decide
- 1
Disconnect power before maintenance
End the session and disconnect both the vacuum and any separately powered clipper before removing components.
- 2
Keep liquids away from motorized parts
Assign a permitted cleaning method to each part; do not spray through hoses or soak electrical assemblies.
- 3
Dry every washed component completely
Reserve a drying area and reinstall washable parts only when the manufacturer's drying requirements are satisfied.
The takeaway
Clean by component, with power disconnected; washing is an instruction to verify, not a default treatment for the kit.